What do you know about the label machine?

The label machine is like the shampoo used in our daily life, and the label on the drink that we drink is used to complete the labeling work. label machines are classified into semi-automatic label machines and fully automatic label machines. From the name, everyone can easily understand it. It is nothing more than the degree of automation. The higher the degree of automation, the more expensive the price.

What are the possible problems and solutions for the label machine?

What should we do if the label machine often breaks?

How to use the label machine correctly?

What are the possible problems and solutions for the label machine?

1. The electric eye failure of the label machine

Solution: Place the label in the detection area of the standard measuring electric eye, slide the label to obtain and disconnect the signal, and observe whether the signal light is flickering in the IO monitor on the touch screen. If the signal light does not flash, the electric eye may be faulty or the connector at the connection may be loose. If the connector is loose, press the connector tightly. If the problem is not resolved, consider the problem of the electric eye and replace the standard electric eye in time.

2. The label paper does not pass through the detection area of the electric eye

Solution: Install the label paper through the detection area of the marking electric eye.

3. Dust, powder, broken labels, etc. block the electric eye detection end of the label machine

Solution: Clean the electric eyes of the label machine in time, pay attention to cleaning under dry conditions, and do not use cleaning tools such as damp cloth.

What should we do if the label machine often breaks?

In the process of debugging new samples, there will be a phenomenon of broken bids. The reasons are many. The following are the reasons and treatment methods of broken bids that frequently occur on label machine.

If it is the problem of the label itself, the cut of the bottom paper of the label is one of the reasons for the label breaking. The obvious phenomenon of this problem is that the fracture is very neat. Upon careful observation, it can be found that the bottom paper of the label has obvious cut marks. In this case, the labeling is caused by the tool pressing too much, and the labeling needs to be redone. The wrong material of the bottom paper of the label will also cause the label to be broken. The standard label machine labels are all glassine, and the bottom paper of the coated paper is due to the insufficient strength of the bottom paper, which causes the label to break.

How to use the label machine correctly?

1. The effective signal of the labeling electric eye of the label machine is not adjusted well

Solution: reset the label measuring electric eye of the label machine. (Set up in accordance with the operating procedure in the manual of each model of standard measuring electric eye)

2. The type of electric eye used for measurement is invalid for the material and nature of the label itself. If transparent labels are used on the label machine, but the detection sensor is an ordinary label measurement sensor, it may happen that the label is continuously peeled off after the sensor detects the object under test.

Solution: Replace the corresponding standard measuring electric eye that can normally detect the effective signal.

Note: Follow the instructions of the label machine. In case of failure, do not disassemble the label machine privately, and contact the label machine supplier as soon as possible.

Dong Guan Do Hearts Technology Co.,Ltd, as a Chinese pioneer in producing label machines, can ensure the products’ quality and the after-sales service