How to use embossing machine?

The high frequency and large current of the embossing machine flow to the heating coil (mostly of the red copper tube), which is wrapped to a ring or other form, thereby creating a strong magnetic flow with an immediate polarity change in the coil, and then passing the magnetic flow through the form, which penetrates the leather surface, in the opposite direction of the leather and the heating current, a correspondingly large vortex current is generated.

What should we consider before using the embossing machine?

How do you care about using the embossing machine?

What parameters should be observed when using an embossing machine?

What should we consider before using the embossing machine?

1. Unpack the package, check the surface and parts of the pre-press for damage, check if the screws are loose if the electrical connections are locked and if the accessories are complete.

2. The embossing machine should be placed on a flat, hard substrate, and the cutting machine must be at least 0,5 meters away from the heat source, and the cutting machine must be at least one meter ahead and behind and there must be at least 0,5 meters left and right for easy operation.

Three. Check the voltage requirements of the shield on the back of the vibration box and make sure the system is well-grounded.

Four. Connect the pre-press to the power and air source and make sure you turn off the mains switch first. Note the voltage requirements of this machine: AC220V, 50-60Hz

Five. The air duct is connected to a clean and lubricating free compressed air source and the nominal working pressure of the pre-press is 0.6 MPa.

Before using the new machine, you must read the pre-press manual and use the pre-press properly.

How do you care about using the embossing machine?

1. Check regularly the water filter of the embossing machine;

2. If the pre-press is dusty, carefully clean the machine with compressed air, but the main power supply must be switched off;

Before checking, it is essential to switch off the main power supply of the embossing machine, as the machine uses several thousand volts to ten thousand volts.

What parameters should be observed when using an embossing machine?

1) Amplitude indicator:

The embossing machine’s function is to determine whether the resonance between the ultrasonic vibrator and the steel form is appropriate. Turn the sound control button to change the measurement value. Generally set to below 50.

2) Amperemeters:

Displays the working flow of the ultrasound. In a load-free state, it indicates the resonance state between the weld head and the system. In general, the normal value of the current meter is 0,4 ~0,6 A, which varies according to output power. When the load is loaded depends on the press area and the complexity and size of the flower wheel.

3) Performance:

Set the output output output of the embossing machine and set it to a different file position, and the display of the amp changes.

After reading, do you have a deeper understanding of the embossing machine? For further information, please contact Dong Guan Do Hearts Technology Co., Ltd. We will be very pleased to help you!