Problems and solutions of wrong glue in the use of dispenser

   When using the glue dispenser,  choice correct glue is very important. If the glue is inverted when the pressure barrel is fed, it will have a great impact on production. The operator needs to clarify the solution. Problems occur during operation, so it is also more important for the technical training of operators.

The effect of glue mixing errors and inversions

Most AB type glue dispensers belong to 1: 1 or 1: 3 medium and low ratio of mixed materials, such as 1: 1, this kind of low-strength rubber means choosing the same rubber barrel, once the operator changes the error in this link, it will be Affects the viscosity ratio, especially the properties of the glue. If there are two or more glues in the bucket, if the glue is replaced by mistake, this situation needs to be solved urgently, because the two-component glue is stronger and faster than the cured, and the contact is fast curing at this time, If it is not cleaned in time, it will gradually solidify in the barrel, and the glue valve, pump material, and even some applied parts are at risk of damage, so we need to pay more attention to avoid losses.

How to handle this situation?

Once the operator misuses the wrong glue and causes confusion in mixing glue, immediately stop the operation of the glue dispenser or glue filling machine.

And use appropriate tools to quickly discharge the wrong glue out of the pressure barrel, then pour a certain amount of alcohol into the pressure barrel to dilute this part of the wrong glue, and take out the valve body, pump body, etc., to prevent the use of mixed glue and reduce the service life. .

It should be noted here that the reason for choosing alcohol instead of banana water is that the latter is corrosive and has a certain impact on the use of auxiliary materials. After the treatment is completed, the operator's skills should be cultivated to prevent the problem of wrong glue from recurring.